Deoiler - OLKLIN-DO-100

OLKLIN®-DO-100

Deoiler

Description:

The formation water collected after demulsification process in heater treater contains little emulsified oil in it. This oil required to be separated out before the water is further injected. A good deoiler perform here to minimize the oil content of the formation water (oil-in water emulsion).

Chemical Composition:

It is composition of cationic polymers and some reaction products.

Specification:

Property	OLKLIN-DO-100
Colour	Water white to pale yellow viscous liquid
Specific gravity	1.00-1.05
Solubility	Soluble in water in all proportions
Self life	12 months (Minimum)

*Properties mentioned and color shown in the photo above is for general idea of the product. Actual product property may vary.

Physical State:

The product is in liquid and homogeneous form and easily pumpable without dilution under all ambient temperature conditions (5 to 45 Deg.C). It should be free from any insoluble matter.

Compatibility & Emulsification Test:

The product should be neutral, non-corrosive and compatible with all materials of construct, including alloys.

Performance:

The laboratory test is carried out on oil-in-water emulsions (formation water) that normally contain up to 2000 ppm of emulsified oil and collected from the oil-water separation plants situated in the oilfields. The treated water is aerated for 15 minutes and then allowed a quiescent time of 5 minutes. After this treatment process, the oil content in the treated water is measured using spectrophotometer that should not be more than 50 PPM. The test dosage of the supplied deoiler is normally not exceed 30n PPM and pegged with the minimum dosage of a field proven product (latest bulk supply), at which it yields the specified oil content in that test emulsion under identical test conditions.

Handling & Precautions:

Safe to handle. Do not take internally.