OLKLIN®-AC-8
Fungicide / Bactericide For Adhesives
In-can Preservative
INTRODUCTION:
“To preserve various rinse-off products like liquid soaps, floor cleaners, wipes, fabric and rug cleaners, conditioners and body washes and inhibit formation of microbes even after application of the product on surface” is the main purpose of using OLKLIN-AC-8. The troublesome microbiological growth can cause number of problems that can be nullified by our product OLKLIN-AC-8, which is broad-spectrum fungicide / biocide, effective over a broad pH range and can be used along with other additives.
CONTENTS OF OLKLIN-AC-8:
It contains safe, effective, and non-hazardous, isothiazolinone compounds as an active ingredient and other additives, which are known for its effectiveness on the microbes.
ADVANTAGES OF USING OLKLIN-AC-8:
- Broad spectrum that effectively controls microbe formation
- Keeps the product at its highest performance even after long storage
- Working on wide pH range
- Work at same lowest dose level on fungi and bacteria
- No formaldehyde and very low toxic at recommended use level
- Compatible with other additives irrespective of their ionic nature
- No colour or odour imparted to the products
- Environmentally acceptable
- Rapidly biodegradable
- Non-persistent in the environment
- Not bio-accumulating
- Hazard free packing
ENVIRONMENTAL RISK ASSESSMENT:
- Rapidly degraded to non-toxic, non-persistent substances
- Degradation does not produce chlorine or chlorinated organics
- Does not affect the performance of wastewater treatment plants
- Does not bioaccumulate
- Predicted environmental concentration (PEC) will have minimal environmental impact
DIRECTION FOR USE:
OLKLIN-AC-8 should be added to the product in the dose range of from as low as 50 to 600ppm on different microbes. Most suitable dose for various microbes is 150 to 300ppm. Considerable long time preservation can be obtained with 0.1% product dose level.
Following general conditions should be maintained during product formulation process for best results:
- Slightly acidic pH values are preferred
- Neutralize free diethanolamine when present (with citric acid for example)
- Eliminate residual SO2 when present, using a suitable oxidizing agent
- During manufacture, add OLKLIN-AC-8 when the temperature is at or below 50°C
- Stearic and phosphoric acids can react with magnesium stabilizers in OLKLIN-AC-8 to form insoluble magnesium stearate and magnesium phosphate salts
- Avoid formulations in which cysteine and zinc pyrithione are present
- OLKLIN-AC-8 can be used effectively in combination with a wide range of preservatives
STORAGE:
Store the product in a cool and dry place away from direct sunlight.
PACKING:
The product is available in 25 to 200 kg HDPE carboys.
SAFETY PRECAUTIONS:
Before handling the product, refer material safety data sheet which contains detailed information about this product (available on request).