Polymer Based Sludge Conditioner For Boilers And Cooling Systems - OLKLIN-SCL

OLKLIN®-SCL

POLYMER BASED SLUDGE CONDITIONER FOR BOILERS AND COOLING SYSTEMS

DESCRIPTION AND USE:

OLKLIN^®-SCL is a specially prepared polymer based treatment for the prevention of scaling in cooling systems, boiler and boiler feed lines by causing calcium and magnesium hardness to form a light mobile floc easily removed by blow-down.

For boilers, OLKLIN^®-SCL is used in conjunction with OLKLIN-OSL for corrosion prevention.

TREATMENT AND DOSAGE REQUIREMENTS:

OLKLIN^®-SCL is normally maintained at concentrations between 20 and 100 ppm in the boiler water or re-circulating cooling water. The correct treatment level for deposit prevention depends on operating conditions, such as pH and operating pressure. The optimum treatment level for any plant will be specified by our technicians.

The viscosity of OLKLIN^®-SCL requires that it be diluted twenty times using clean, cold water before pumping. OLKLIN^®-SCL is non-corrosive to steel mixing tanks or dosing pumps.

ADVANTAGES:

•    Economical to use - effective at low dosage levels.
•    Performs well over a wide pH range, it does not alter the system pH.
•   Eliminates or reduces the use of inorganic salts.

STANDARD PACKAGING:

OLKLIN^®-SCL is available in 50 Kg and 200 Kg containers.

SAFETY INFORMATION:

Gloves and goggles should be worn when handling the concentrated solution. (See Material Safety Data Sheets for further information).

STORAGE AND HANDLING:

Store in dry place away from direct sunlight.

Spillages should be cleaned up rapidly; surfaces will become very slippery if wetted.

The information given herein is believed to be reliable. However, no guarantee is made or liability assumed. Manhar Specialities does not know of all of the uses to which its products may be utilized or the condition of use. Therefore, Manhar Specialities makes no warranty concerning the fitness or suitability of the product for a particular use or purpose.